Nail drill Strong 210 (pen 105L) Copy
Nail drill Strong 210 (pen 105L) Copy
Specifications
Main part
1.Rated volage :110V-120V/60HZ,220V-240V /50HZ
Please set the voltage before using the machine?
2.Power Inpute: 65W
3.Out voltage:DC0-32V
4.Rated Speed:35000RPM(Max)
Package Include:
1x Main Machine; 1x Handpiece; 1x Foot W witch; 1x Handpiece Support 1x User Manua(English) Please tun off the switch when you do not use the unit.
1 .Do not work in a dangerous place. Do not use the control box in a humid place.ac
2 .Transport and storage conditions: Temperature: 10-40? Humidity: 30-75% RH Atmospheric Pressure :700 hPa to 1060 hPa
3. Our handpiece & foot pedal should be only used for our confrol unit
4.Bur *Dimensions of the bur. 2.35mm (SO7785-2 TYPE2) *Minimum iting length of bur of bur :10mm *When locked in the chuck, the maximum projection length of should be less than 35mm Use a bur that conform to the ISO standards Avoid using a rusty or bent bur that may cause excessive wear of bearings. Keep safe speed, and precautions recommended by bur manufacturer.
5.Check for any troubles, inctuding vibration of bur,at low speed, and then start high speed
6.Operate the speed control dial in control box softly 7.use a fuse of 220V/230V/2A for control box.
8.Turn off the power in order to change the bur.
9.Be coreful not to drop the handpiece as it may be damaged or broken. in case that it is drooped, check if the bur is bent or if any excessive heat is generated while carefully operating it.
10.if any problem occurs in handpiece, use after repaining.
11.Do not tumon the power of control box while the collet chuck of handpiece open (Short circuit of the motor may be coused)
12 .Make sure that the switch is off before putting the power plug in the socket, in order to avoid on unexpected injury due to sudden start.
13.A circuit breaker is provided to protect the motor. it is actuated when there on overload which the motor cannot stand. Work within a range of load which it is not actuated.
14.Do not open the chuck while operating.
15.keep the handpiece with setting a bur to the collet chuck affer opperation.
16.Do not put the handpiece down befare it stops completely.
17.Besre to pul out the power cord before moving the control box.
18.use the specified voltage.
19.use accessories suitable for this product.
20.For recommended speed in various applications, follow the manufacture's instructions.
21.Wear proper profecive cothes and equipment ;including a dust mask and safety goggles. Use a proper suction unit and a ventilator.
22.keep the workplace clean. Debris may cause on accident.
Warranty: 6 months